Cisco Cisco Aironet 1200 Access Point Notas de publicación

For instructions on installing access point software:

Follow this link to the Cisco Aironet Install and Upgrade page:

Click this link to browse to the Cisco IOS Software Center on Cisco.com: 

Log into Cisco.com to use the Cisco IOS Upgrade Planner. 

If your 1200 series access point does not run IOS software, you can use the conversion utility or the 
conversion image to convert the access point system to IOS software. Use the conversion utility to 
maintain the current configuration after the conversion, or load the conversion image to convert to IOS 
software without saving the current configuration. Your access point must run one of these VxWorks 
firmware versions before you can convert to IOS software: 12.03T, 12.02T1, 12.01T1, 12.00T, 11.56, or 
11.54T.

The upgrade image and the conversion tool do not support VxWorks version 12.04. Access points 
running operating system version 12.04 must be downgraded to a supported operating system version 
before using the upgrade image or the conversion tool.

To download the conversion utility or the converter image, click this link to browse to the Cisco IOS 
Software Center on Cisco.com: 

Log into Cisco.com to use the Feature Navigator or the Cisco IOS Upgrade Planner, or click Wireless 
Software to go to the Wireless LAN Software page. Download the conversion utility or the conversion 
image for 1200 series access points. You can also download instructions for using the utility and the 
image.

This section lists new features in Cisco IOS Release 12.2(11)JA.

Wi-Fi Protected Access (WPA) is now supported on Cisco Aironet access points. WPA is the Wi-Fi 
Alliance specification for interoperable wireless LAN security. It supports IEEE 802.1X authentication 
using extensible authentication protocol (EAP) authentication types and temporal key integrity protocol 
(TKIP) encryption.