Cisco Cisco Aironet 1200 Access Point Notas de publicación

CSCeh77143—802.11b access point radios now return a calibrated signal quality value

CSCeh90918—The SNTP broadcast client no longer ignoreS NTP broadcasts from a v4 server

CSCei38233—1200 series access point now returns chassis Id top assembly number

CSCei49361—A warning message is now printed if network-eap is configured

CSCei66849—350 series access points no longer displays interrupt CPU greater than total CPU

CSCej11428—Repeater access point interfaces no longer go down when station leaves RF coverage 
area

CSCej34945—VTY lines on access points has been reduced from 16 to 5 but user has option to 
configure up to 16 lines

CSCsa98253—access point now displays warning when an MBSSID is configured on non-MBSSID 
radio

CSCsb19033—shut/no shut dot11radio interface command no longer causes output drops

CSCsb23595—1100 series access point autoinstall no longer writes to NVRAM after loading a 
configuration from a TFTP server

CSCsb34761—350 series access point no longer shows error on the SSID Manager page after 
performing an IOS upgrade

CSCsb47156—SSID can now be created on the Express Security page

CSCsb48761—Memory fragmentation caused by MAC authentication failures no longer occurs

This caveat is duplicated by CSCsb77105 and CSCsc99333.

CSCsb53874—Mobile nodes no longer experience dot1x authentication fail  at timing of 
reauth-period when using MAC or EAP authentication

This caveat is duplicated by CSCsb59272.

CSCsb60153—WLSM now recognizes passive client IP addresses

CSCsb62170—GUI now allows multiple SSIDs to be mapped to a VLAN

CSCsb62483—Access point no longer caches PMK ID for 90 minutes or more when mobile nodes 
roam between access points.

CSCsb72175—Power translation table has been clarified in IOS GUI

CSCsb72354—AES+TKIP & AES+TKIP+WEP now operates normally.

CSCsb73319—32 character SSID no longer fails with WDS

This caveat is duplicated by CSCsb73268.

CSCsb92517—Message is now logged if the VLAN name from the RADIUS server is not found

CSCsb92558—SSID values with embedded OOO or xHH directives are parsed properly

CSCsb98295—Fallback function now shuts down radio interface when the access point boots 
without an Ethernet connection

CSCsb98627—1300 series outdoor access point/bridge CCA value is no longer reset to 75 on reload 
when disabled

CSCsb98674—Configuring path command no longer causes the access point to reload

CSCsc05092—1300 series outdoor access point/bridge now ages and upgrades bridging table

This caveat is duplicated by CSCsc61203.

CSCsc09309—Timeout error no longer reported during WLSE radio scan due to a busy channel