Cisco Cisco Aironet 1000 Series Lightweight Access Point Guía De Instalación

Where: 

<pool name> is the name of the DHCP pool, such as AP1000

<IP Network> is the network IP address where the controller resides, such as 10.0.18.1

<Netmask> is the subnet mask, such as 255.255.255.0

<Default router> is the IP address of the default router, such as 10.0.0.1

<DNS Server> is the IP address of the DNS server, such as 10.0.10.2

Add the Option 60 line using the following syntax:

Add the Option 43 line using the following syntax:

<comma separated IP address list>

For example, if you are configuring Option 43 for Cisco Aironet 1000 series access points 
using the controller IP addresses 10.126.126.2 and 10.127.127.2, add the following line to 
the DHCP pool in the Cisco IOS CLI. Be sure to include the quotation marks:

If you followed the instructions in previous sections of this guide, you should have no trouble getting 
your access point deployed in your network. However, if you did experience difficulty, help is available 
from Cisco. Before contacting Cisco, look for a solution to your problem in the following places:

The troubleshooting section of this guide.

The troubleshooting section of the Cisco Aironet 1000 Series Lightweight Access Point Hardware 
Installation Guide.

The Tools and Resources section on the Technical Support and Documentation page at cisco.com.

Follow these steps to contact the Technical Assistance Center on cisco.com:

Open your browser and go to http://www.cisco.com/.

Click Technical Support and Documentation. A pop-up window appears.

In the pop-up window, click Technical Support and Documentation. The Technical Support 
and Documentation page appears.