Cisco Cisco Aironet 1200 Access Point Notas de publicación
4
Installation Notes
OL-3641-01
Installation Notes
Installation Notes
You can find the latest release of access point firmware at this URL:
Installation in Environmental Air Space
Cisco Aironet 1200 Series Access Points are suitable for use in environmental air space in accordance
with Section 300-22(c) of the National Electrical Code.
with Section 300-22(c) of the National Electrical Code.
Note
If you plan to mount the access point in an area subject to environmental air space with the intention
of upgrading to a 5-GHz radio, Cisco recommends that you mount the access point horizontally so
that its antennas point down. Doing so ensures that the access point complies with regulatory
requirements for environmental air space after the 5-GHz radio is installed.
of upgrading to a 5-GHz radio, Cisco recommends that you mount the access point horizontally so
that its antennas point down. Doing so ensures that the access point complies with regulatory
requirements for environmental air space after the 5-GHz radio is installed.
Caution
The Cisco Aironet Power Injector has a smaller operating temperature range (32 to 104
o
F; 0 to 40
o
C)
than the 1200 series access point. The power injector is not intended for use in extremely high or low
temperatures or in environmental air spaces, such as above suspended ceilings.
temperatures or in environmental air spaces, such as above suspended ceilings.
Antenna Installation
For instructions on the proper installation and grounding of external antennas, refer to the National Fire
Protection Association’s NFPA 70, National Electrical Code, Article 810, and the Canadian Standards
Association’s Canadian Electrical Code, Section 54.
Protection Association’s NFPA 70, National Electrical Code, Article 810, and the Canadian Standards
Association’s Canadian Electrical Code, Section 54.
Warning
Do not install the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Power Considerations
This section describes issues you should consider before applying power to the access point.
Caution
The nominal voltage for 1200 series access points is 48 VDC, and the access point is operational up
to 60 VDC. Voltage higher than 60 VDC can damage the equipment.
to 60 VDC. Voltage higher than 60 VDC can damage the equipment.
Caution
Cisco Aironet Power Injectors are designed for use with 1200 series access points only. Do not use
the power injector with any other Ethernet-ready device. Using the power injector with other
Ethernet-ready devices can damage the equipment.
the power injector with any other Ethernet-ready device. Using the power injector with other
Ethernet-ready devices can damage the equipment.