Cisco Cisco Aironet 1200 Access Point Notas de publicación
9
Important Notes
OL-3641-01
Important Notes
Important Notes
This section lists important information about access points running firmware version 12.01T.
Adding or Deleting Proxy Mobile IP AAPs
If you need to add or delete proxy Mobile IP authoritative access points, you must disable proxy Mobile
IP before changing the configuration. Follow these steps.
IP before changing the configuration. Follow these steps.
Step 1
Browse to the Setup page.
Step 2
In the Services section, click Proxy Mobile IP. The Proxy Mobile IP Setup page appears.
Step 3
Click General. The Proxy Mobile IP General page appears.
Step 4
Change the Enable Proxy Mobile IP setting to no.
Step 5
Add or delete AAPs as necessary.
Step 6
Change the Enable Proxy Mobile IP setting to yes.
Unexpected Results on Lost Ethernet
When backbone connectivity is lost on an access point running version 12.01T, the device switches to
repeater mode. Switch to Repeater mode is the default setting for this condition. Therefore, if the access
point’s role in your network is not a repeater access point, make sure you connect it to your wired
network before booting it up. If you do not connect the access point to your network, it switches to the
repeater mode when it fails to detect the presence of an Ethernet connection. When this occurs, wireless
client devices are unable to connect and you cannot correct the problem using a wireless client. The only
way you can change the configuration is through a serial connection using the access point’s command
line interface.
repeater mode. Switch to Repeater mode is the default setting for this condition. Therefore, if the access
point’s role in your network is not a repeater access point, make sure you connect it to your wired
network before booting it up. If you do not connect the access point to your network, it switches to the
repeater mode when it fails to detect the presence of an Ethernet connection. When this occurs, wireless
client devices are unable to connect and you cannot correct the problem using a wireless client. The only
way you can change the configuration is through a serial connection using the access point’s command
line interface.
Error Message Appears for Access Points with One Radio
When you install firmware version 12.01T in an access point with one radio, an error message appears.
If your access point contains only the internal 2.4-GHz radio, this error message appears:
If your access point contains only the internal 2.4-GHz radio, this error message appears:
** Failed to Load Driver for device entry #3.
If your access point contains only the external 5-GHz radio, this error message appears:
** Failed to Load Driver for device entry #2.
You can ignore these messages. The errors do not appear if your access point contains two radios.
Enabling Broadcast Key Rotation on One Radio Enables It on Both Radios
If you enable Broadcast Key Rotation on one of the radios in a dual-radio access point, Broadcast Key
Rotation is automatically enabled on the other radio.
Rotation is automatically enabled on the other radio.