Cisco Cisco Aironet 1250 Series Access Point Guía De Instalación
25
Quick Start Guide: Cisco Aironet 1250 Series Access Point
Follow these steps to connect the access point to an Ethernet LAN when you
are using a local power source:
are using a local power source:
Step 1
Connect a Category 5E (or higher) Ethernet cable to the RJ-45
Ethernet connector labeled Ethernet on the access point.
Ethernet connector labeled Ethernet on the access point.
Step 2
Connect the 1250 series DC power module’s output connector to the
access point’s DC-IN power connector.
access point’s DC-IN power connector.
Step 3
Plug the other end of the Ethernet cable into an unpowered Ethernet
port on your LAN network.
port on your LAN network.
Step 4
Plug the 1250 series DC power module’s AC power cord into an
approved 100- to 240-VAC outlet.
approved 100- to 240-VAC outlet.
Configuring the Access Point
How you configure your access point depends on how you intend to use it in
your wireless network. This guide provides a brief synopsis of the
configuration process. For detailed information, refer to the “Configuring the
Access Point for the First Time” chapter of the Cisco IOS Software
Configuration Guide for Cisco Aironet Access Points for the Cisco IOS
release you are using.
your wireless network. This guide provides a brief synopsis of the
configuration process. For detailed information, refer to the “Configuring the
Access Point for the First Time” chapter of the Cisco IOS Software
Configuration Guide for Cisco Aironet Access Points for the Cisco IOS
release you are using.