Cisco Cisco Aironet 1200 Access Point Notas de publicación
8
Release Notes for Cisco Aironet 350, 1100, and 1200 Series Access Points for Cisco IOS Release 12.2(15)JA
OL-5263-01
Important Notes
Antenna Installation
For instructions on the proper installation and grounding of external antennas for 1200 series access
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
Warning
Do not install the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Important Notes
This section describes important information about the access point.
TFTP Required to Upgrade 1200 Series Access Points to this Release
Software upgrades fail when you use the web-browser interface to install Cisco IOS Release 12.2(15)JA
on 1200 series access points. The image size exceeds the access point’s 4-MB restriction for software
upgrades. Use TFTP to upgrade your 1200 series access point to this release. For complete instructions
on using TFTP to upgrade access point software, see the “Working with Software Images” section in the
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points.
on 1200 series access points. The image size exceeds the access point’s 4-MB restriction for software
upgrades. Use TFTP to upgrade your 1200 series access point to this release. For complete instructions
on using TFTP to upgrade access point software, see the “Working with Software Images” section in the
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points.
Default Username and Password Are Cisco
When you open the access point interface, you must enter a username and password. The default
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
New Express Security Page Simplifies Security Setup
The new Express Security page in the access point web-browser interface makes it easier to create SSIDs
and assign security settings to them.
and assign security settings to them.
shows the Express Security page.
Limitations of the Express Security page include:
•
You cannot edit SSIDs. However, you can delete SSIDs and re-create them.
•
You cannot assign SSIDs to specific radio interfaces. The SSIDs that you create are enabled on all
radio interfaces. To assign SSIDs to specific radio interfaces, use the Security SSID Manager page.
radio interfaces. To assign SSIDs to specific radio interfaces, use the Security SSID Manager page.
•
You cannot configure multiple authentication servers. To configure multiple authentication servers,
use the Security Server Manager page.
use the Security Server Manager page.
•
You cannot configure multiple WEP keys. To configure multiple WEP keys, use the Security
Encryption Manager page.
Encryption Manager page.
•
You cannot assign an SSID to a VLAN that is already configured on the access point. To assign an
SSID to an existing VLAN, use the Security SSID Manager page.
SSID to an existing VLAN, use the Security SSID Manager page.