Cisco Cisco Aironet 1240 AG Access Point Guía De Instalación
20
OL-16714-01
Note
The Cisco part number for the serial cable is
AIR-CONCAB1200.
AIR-CONCAB1200.
2.
Set up a terminal emulator on your PC to communicate with the access
point. Use the following settings for the terminal emulator connection:
9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
point. Use the following settings for the terminal emulator connection:
9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
Assigning an IP Address Using the CLI
When you assign an IP address to the access point by using the CLI, you must
assign the address to the BVI. Beginning in a privileged EXEC mode, follow
these steps to assign an IP address to the access point BVI using the access
point console port.:
assign the address to the BVI. Beginning in a privileged EXEC mode, follow
these steps to assign an IP address to the access point BVI using the access
point console port.:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
Interface bvi1
Enters interface configuration mode
for the BVI.
for the BVI.
Step 3
ip address address mask
Assigns an IP address and subnet mask
address to the BVI.
address to the BVI.