Cisco Cisco Aironet 1040 Series Access Point Manual Técnica
Autonomous Aironet Access Points and Multiple
SSIDs on Cisco IOS Configuration Example
SSIDs on Cisco IOS Configuration Example
Document ID: 116118
Contributed by Surendra BG, Cisco TAC Engineer.
May 29, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Video
AP Configuration
Step 1. Configure the SSID and map it to respective VLANS.
Step 2. Assign encryption to different SSIDs with respective VLANs.
Step 3. Configure the subinterface for Dot11 radio 0 and Ethernet.
Step 4. Verify.
Manage the AP with a Management IP Address
Verify
Prerequisites
Requirements
Components Used
Background Information
Video
AP Configuration
Step 1. Configure the SSID and map it to respective VLANS.
Step 2. Assign encryption to different SSIDs with respective VLANs.
Step 3. Configure the subinterface for Dot11 radio 0 and Ethernet.
Step 4. Verify.
Manage the AP with a Management IP Address
Verify
Introduction
This document describes how to configure multiple service set identifiers (SSIDs) with multiple VLANs on
Cisco IOS
Cisco IOS
®
software and autonomous Cisco Aironet Access Points.
Prerequisites
Requirements
This configuration example assumes you have configured the DHCP pool on the Cisco IOS switch or router
or on a dedicated DHCP server.
or on a dedicated DHCP server.
In order to complete this configuration, Cisco recommends that you have basic knowledge of Cisco IOS CLI
commands.
commands.
Components Used
Any switch that runs Cisco IOS and supports Multilayer Switching (MLS)
•
Cisco Aironet Access Points
•
Background Information
The SSID is a unique identifier that wireless networking devices use to establish and maintain wireless
connectivity. Multiple access points on a network or subnetwork can use the same SSIDs. SSIDs are case
connectivity. Multiple access points on a network or subnetwork can use the same SSIDs. SSIDs are case