Cisco Cisco Aironet 1600i Access Point Manual Técnica

WDS on Cisco Autonomous Access Points Version
15.2(4)JA with Local RADIUS Server Configuration
Example

Document ID: 116597

Contributed by Maithri B and Surendra BG, Cisco TAC Engineers.

Oct 18, 2013

Contents

Introduction
Prerequisites
Requirements
Components Used
Configure
GUI Configurations
Create the SSID
Local RADIUS Server Configuration on WDS AP
Local RADIUS Server Configuration on WDS Client AP
Enable WDS on WDS AP
Enable WDS on WDS Client AP
CLI Configurations
WDS AP
WDS Client AP
Verify
CLI Verification Output on WDS AP
CLI Verification Output on WDS Client AP
Troubleshoot

Introduction

This document describes how to configure Wireless Domain Services (WDS) on an autonomous access point
(AP) setup with a local RADIUS server. The document focuses on configurations through the new GUI, but
also provides command−line interface (CLI) configurations.

Prerequisites

Requirements

Cisco recommends that you have knowledge of basic GUI and CLI configuration on autonomous APs.

Components Used

The information in this document is based on these software and hardware versions:

Cisco 3602e Series Access Point on Autonomous AP IOS

Software, Release 15.2(4)JA1; this device

will act as a WDS AP and local RADIUS server.

•