Cisco Cisco Aironet 3600i Access Point Guía De Instalación
4
Installing the 802.11ac Radio Module for Cisco Aironet 3600 Series Access Points
Installing the Module
Installing the Module
Follow these steps to install the module:
Step 1
Remove the module from the packaging.
Step 2
Power down the access point.
Note
If you install a module while the AP is powered on, the AP will reboot.
Step 3
Peel off the Module Port Protective Cover from the back of the access point to reveal the module port
connector, labeled 2 in the following figure.
The PCIe connector on the module will go into the AP’s module port connector.
connector, labeled 2 in the following figure.
The PCIe connector on the module will go into the AP’s module port connector.
345379
1
2
1
1
Openings for module’s antennas
2
Removable Module Port Protective Cover