Cisco Cisco Aironet 3600i Access Point Guía De Instalación
8
Installing the 802.11ac Radio Module for Cisco Aironet 3600 Series Access Points
Removing the Installed Module
Removing the Installed Module
Follow these steps to remove the installed module:
Step 1
Power down the access point.
Caution
If you loosen the thumbscrews or try to remove a module while the AP is powered on, the AP will reboot.
The thumbscrews are not only used to mechanically secure the radio module into the AP, but are also an
integral part of the radio module detection circuitry within the AP.
The thumbscrews are not only used to mechanically secure the radio module into the AP, but are also an
integral part of the radio module detection circuitry within the AP.
Step 2
Unscrew the thumb screws on the module, by hand.
Step 3
Pull out the module gently.
Step 4
Power up the access point.
353087