Cisco Cisco SF302-08PP 8-port 10 100 PoE+ Managed Switch Referencia técnica
24
78-20269-01 Command Line Interface Reference Guide
362
Power over Ethernet (PoE) Commands
24.1
power inline
24.1
power inline
Use the power inline Interface Configuration mode command to configure the
power on an interface.
power on an interface.
Syntax
power inline
{auto | never} [time-range time-range-name]
Parameters
•
auto—Turns on the device discovery protocol and applies power to the
device.
device.
•
never—Turns off the device discovery protocol and stops applying power
to the device.
to the device.
•
auto time-range-name—Turns on the power in the specified time range.
When the time range is not in effect the power is not supplied to the
attached device. If a time range is not specified, there is no time range
bound to the port.
When the time range is not in effect the power is not supplied to the
attached device. If a time range is not specified, there is no time range
bound to the port.
•
never time-range-name—Turns off the power to the device in the specified
time range. When the time range is not in effect the power is supplied to the
attached device. If a time range is not specified, there is no time range
bound to the port.
time range. When the time range is not in effect the power is supplied to the
attached device. If a time range is not specified, there is no time range
bound to the port.
Default Configuration
The default configuration is set to auto.
Command Mode
Interface Configuration (Ethernet) mode