Cisco Cisco SF302-08PP 8-port 10 100 PoE+ Managed Switch Manual De Mantenimiento
Multicast
IPv4 Multicast Configuration
Cisco 300 Series Managed Switches Administration Guide
298
16
STEP 6
Click Apply. The Running Configuration file is updated.
NOTE
Changes in IGMP Snooping timers configuration, such as: Query Robustness,
Query Interval etc. do not take effect on timers which were already created.
Query Interval etc. do not take effect on timers which were already created.
IGMP VLAN Settings
To configure IGMP on a specific VLAN:
STEP 1
Click Multicast > IPv4 Multicast Configuration > IGMP VLAN Settings.
The following fields are displayed for each VLAN on which IGMP is enabled:
•
Interface Name—VLAN on which IGMP snooping is defined.
•
Router IGMP Version—Version of IGMP Snooping.
•
Query Robustness—Enter the number of expected packet losses on a link.
•
Query Interval (sec)—Interval between the General Queries to be used if
this device is the elected querier.
this device is the elected querier.
•
Query Max Response Interval (sec)—Delay used to calculate the Maximum
Response Code inserted into the periodic General Queries.
Response Code inserted into the periodic General Queries.
•
Last Member Query Interval (msec)—Enter the Maximum Response Delay
to be used if the device cannot read Max Response Time value from group-
specific queries sent by the elected querier.
to be used if the device cannot read Max Response Time value from group-
specific queries sent by the elected querier.
STEP 2
Select an interface, and click Edit. Enter the values of the fields described above.
STEP 3
Click Apply. The Running Configuration file is updated.