Cisco Cisco SF302-08PP 8-port 10 100 PoE+ Managed Switch Manual De Mantenimiento
IP Configuration
Domain Name
361
Cisco 300 Series Managed Switches Administration Guide
17
•
All Dynamic & Static—Deletes the static and dynamic hosts.
The Host Mapping Table displays the following fields:
•
Host Name—User-defined host name or fully-qualified name.
•
IP Address—The host IP address.
•
IP Version—IP version of the host IP address.
•
Type—Is this a Dynamic or Static entry to the cache.
•
Status— Displays the results of attempts to access the host
-
OK
—Attempt succeeded.
-
Negative Cache
—Attempt failed, do not try again.
-
No Response
—There was no response, but system can try again in
future.
•
TTL (Sec)— If this is a dynamic entry, how long will it remain in the cache.
•
Remaining TTL (Sec)— If this is a dynamic entry, how much longer will it
remain in the cache.
remain in the cache.
STEP 3
To add a host mapping, click Add.
STEP 4
Enter the parameters.
•
IP Version—Select Version 6 for IPv6 or Version 4 for IPv4.
•
IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
options are:
-
Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
reachable from other networks.
•
Link Local Interface—If the IPv6 address type is Link Local, select the
interface through which it is received.
interface through which it is received.