Cisco Cisco Packet Data Interworking Function (PDIF) Documentation Roadmaps
ST16 Hardware Platform Overview
▀ Application and Line Cards
▄ Cisco ASR 5000 Series Product Overview
OL-22937-01
Figure 22. Switch Processor I/O Card
../../../GRAPHICS/Production/ST-series_Hardware/ST-series_SPIO_BNC_callout.wmf
Table 10.
SPIO Callout Definitions
Number
Description
1
Card Ejector Levers—Use to insert/remove card to or from the chassis.
2
Interlock Switch—When pulled downward, the interlock switch notifies the system to safely power down card prior to
removal.
removal.
3
Card Level Status LEDs—Show the status of the card. See the Hardware Installation Guide for definitions.
4
Optical Gigabit Ethernet Management LAN Interfaces—Two Small Form-factor Pluggable (SFP) optical Gigabit
Ethernet interfaces to connect optical transceivers.
Ethernet interfaces to connect optical transceivers.
5
10/100/1000 Mbps Ethernet Management LAN Interfaces—Two RJ-45 interfaces, supporting 10/100 Mbps or 1
Gbps Ethernet.
Gbps Ethernet.
6
Console Port—RJ-45 interface used for local connectivity to the command line interface (CLI).
7
BITS Timing Interface—Either a BNC interface or 3-pin wire wrap connector. Used for application services that use
either the optical or channelized line cards.This interface is not used for systems supporting data services.
either the optical or channelized line cards.This interface is not used for systems supporting data services.
8
CO Alarm Interface—Dry contact relay switches, allowing connectivity to central office, rack, or cabinet alarms. See
the Hardware Installation Guide for more information.
the Hardware Installation Guide for more information.
Management LAN Interfaces
SPIO management LAN interfaces connect the system to the carrier‘s management network and subsequent
applications, normally located remotely in a Network Operations Center (NOC). You can use the RJ-45 10/100/1000
Mbps Ethernet interfaces or optical SFP Gigabit Ethernet interfaces.
applications, normally located remotely in a Network Operations Center (NOC). You can use the RJ-45 10/100/1000
Mbps Ethernet interfaces or optical SFP Gigabit Ethernet interfaces.
When using the RJ-45 interfaces, CAT5 shielded twisted pair cabling is recommended.
Important:
Use shielded cabling whenever possible to further protect the chassis and its installed
components from ESD or other transient voltage damage.
Table 11.
SFP Interface Supported Cable Types
Module
Type
Card
Identification
Interface Type
Cable Specifications
1000Base-
SX
SX
Ethernet
1000 SX
1000 SX
Fiber, LC
duplex female
connector
duplex female
connector
Fiber Type: Multi-mode fiber (MMF), 850 nm wavelengthCore Size
(microns)/Range:62.5/902.23 feet (275 meters)50/1640.42 feet (500
meters)Minimum Tx Power: -9.5 dBmRx Sensitivity: -17 dBmPlease read all the
notices and warnings for Class 1 Laser devices following this table before handling
this component.
(microns)/Range:62.5/902.23 feet (275 meters)50/1640.42 feet (500
meters)Minimum Tx Power: -9.5 dBmRx Sensitivity: -17 dBmPlease read all the
notices and warnings for Class 1 Laser devices following this table before handling
this component.