Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Context Configuration Mode Commands
ip arp ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
ip arp
Configures the address resolution protocol options for the current context.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Indicates the ARP configuration data for the IP address specified is to be removed from the configuration.
Specifies the IP address to configure the ARP options where
must be specified using the
standard IPv4 dotted decimal notation.
Specifies the media-specific access control layer address for the IP address.
must be
specified as a an 6-byte hexadecimal number with each byte separated by a colon, e.g., ‗AA:12:bb:34:f5:0E‘.
This keyword associates a Virtual Routing and Forwarding (VRF) context with this static ARP entry.
is name of a preconfigured virtual routing and forwarding (VRF) context configured in Context
configuration mode through
command.
Usage
Manage the IP address mapping which is a logical/virtual identifier to the more lower layer addressing used
for address resolution in ICMP messages.
For tunnel-based interface, network IP pool can have overlapping ip-addresses across VRFs. To manage it
adding a preconfigured VRF context is required to associate with an static ARP entry. By default, the ARP is
added in the given context. If the VRF name is specified, then the ARP is added to the VRF ARP table.
for address resolution in ICMP messages.
For tunnel-based interface, network IP pool can have overlapping ip-addresses across VRFs. To manage it
adding a preconfigured VRF context is required to associate with an static ARP entry. By default, the ARP is
added in the given context. If the VRF name is specified, then the ARP is added to the VRF ARP table.
Example
The following commands set the IP and MAC address for the current context then remove it from the configuration.
The following commands set the IP and MAC address for the current context then remove it from the configuration.
The following commands set the IP and MAC address for a VRF context GRE_vrf1 in the configuration.