Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
DHCP Service Configuration Mode Commands
T1-threshold ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
T1-threshold
Configures the DHCP T1 timer as a percentage of the allocated IP address lease.
Product
GGSN, ASN-GW
Privilege
Security Administrator, Administrator
Syntax
Default: 50%
The percentage of the allocated IP address lease time at which the DHCP call-line state is changed to
―RENEWING‖. It can be configured to any integer value from 40 to 66%.
The percentage of the allocated IP address lease time at which the DHCP call-line state is changed to
―RENEWING‖. It can be configured to any integer value from 40 to 66%.
Usage
This command is used to identify the time at which a subscriber must renew their DHCP lease as a
percentage of the overall lease time. (Refer to the
percentage of the overall lease time. (Refer to the
command in this chapter for
information on configuring the IP address lease period.)
For example, if the lease-duration was configured to have a maximum value of 12000 seconds, and this
command is configured to 40%, then the subscriber would enter the RENEWING state after 4800 seconds.
For example, if the lease-duration was configured to have a maximum value of 12000 seconds, and this
command is configured to 40%, then the subscriber would enter the RENEWING state after 4800 seconds.
Example
The following command configures the T1 threshold to 40%:
The following command configures the T1 threshold to 40%: