Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Ethernet Port Configuration Mode Commands
threshold high-activity ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
threshold high-activity
Configures thresholds for high port activity for the port.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Default: 50
The high threshold high port activity percentage that must be met or exceeded within the polling interval to
generate an alert or alarm.
The high threshold high port activity percentage that must be met or exceeded within the polling interval to
generate an alert or alarm.
can be configured to any integer value between 0 and 100.
Allows the configuration of the low threshold.
Default: 50
The low threshold high port activity percentage that maintains a previously generated alarm condition. If the
activity percentage falls below the low threshold within the polling interval, a clear alarm will be generated.
The low threshold high port activity percentage that maintains a previously generated alarm condition. If the
activity percentage falls below the low threshold within the polling interval, a clear alarm will be generated.
can be configured to any integer value between 0 and 100.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
High port activity thresholds generate alerts or alarms based on the utilization percentage of each configured
port during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for high port activity based on the following rules:
port during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for high port activity based on the following rules:
Enter condition: Actual percent utilization of a port ³ High Threshold
Clear condition: Actual percent utilization of a port < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command in the Global Configuration Mode Commands chapter of this
reference to configure the polling interval and the
command in this chapter to
enable thresholding for this value.
Example