Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Firewall-and-NAT Policy Configuration Mode Commands
▀ nat private-ip-flow-timeout
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
nat private-ip-flow-timeout
This command configures the Private IP NPU flow timeout setting.
Product
NAT
Privilege
Security Administrator, Administrator
Syntax
Configures the default setting.
Default: 180 seconds
Default: 180 seconds
Disables the Private IP NPU flow timeout configuration.
When disabled, the flow is installed at call setup and will be removed only when the subscriber disconnects.
When disabled, the flow is installed at call setup and will be removed only when the subscriber disconnects.
Specifies the Private IP NPU flow timeout period in seconds.
must be an integer from 180 through 86400.
Usage
Use this command to configure the Private IP NPU flow timeout setting.
For NAT-enabled calls, by default, the downlink private IP NPU flow will not be installed at call setup for a
subscriber session. The flow will only be installed on demand. When there is no traffic on the private flow,
the private IP flow will be removed after the configurable timeout period.
For NAT-enabled calls, by default, the downlink private IP NPU flow will not be installed at call setup for a
subscriber session. The flow will only be installed on demand. When there is no traffic on the private flow,
the private IP flow will be removed after the configurable timeout period.
Example
The following command configures the Private IP NPU flow timeout setting to
The following command configures the Private IP NPU flow timeout setting to
seconds: