Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Global Configuration Mode Commands
▀ threshold asngw-max-eap-retry
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
threshold asngw-max-eap-retry
Configures thresholds for maximum retries for Extensible Authentication Protocol (EAP) authentication on an ASN-
GW service.
GW service.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Syntax
Default: 0
The high threshold number of retries for EAP authentication that must be met or exceeded within the polling
interval to generate an alert or alarm.
The high threshold number of retries for EAP authentication that must be met or exceeded within the polling
interval to generate an alert or alarm.
can be configured to any integer value between 0 and 10000000. A value of 0 disables the
threshold.
Default: 0
The low threshold number of retries for EAP authentication that maintains a previously generated alarm
condition. If the number of retries falls beneath the low threshold within the polling interval, a clear alarm
will be generated.
The low threshold number of retries for EAP authentication that maintains a previously generated alarm
condition. If the number of retries falls beneath the low threshold within the polling interval, a clear alarm
will be generated.
can be configured to any integer value between 0 and 10000000. A value of 0 disables the
threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set threshold limits to generate alerts or alarms based on the number of retries for EAP
authentication that occur during the specified polling interval.
Alerts or alarms are triggered for maximum number of retries for EAP authentication based on the following
rules:
authentication that occur during the specified polling interval.
Alerts or alarms are triggered for maximum number of retries for EAP authentication based on the following
rules:
Enter condition: Actual number of failures ³ High Threshold
Clear condition: Actual number of failures < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.