Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
HNB-GW Service Configuration Mode Commands
rtp address ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
rtp address
This command configures the Real Time Protocol (RTP) address on HNB-GW and send it HNB to map RTP streams
with this IP while HNB-GW connects to MSC/VLR through IuCSoIP (IuCS-over-IP) tunnel. This command is used for
RTP stream management on HNB-GW.
with this IP while HNB-GW connects to MSC/VLR through IuCSoIP (IuCS-over-IP) tunnel. This command is used for
RTP stream management on HNB-GW.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Syntax
Removes the RTP IP address association to be used for communication between HNB and HNB-GW while
communicating with MSC/VLR -GW through IuCS over IP tunnel.
communicating with MSC/VLR -GW through IuCS over IP tunnel.
Specifies the IP address of HNB-GW to use as an end point by HNB and HNB maps the RTP streams with
this IP address and HNB-GW communicates with MSC/VLR through IuCS-over-IP Tunnel.
this IP address and HNB-GW communicates with MSC/VLR through IuCS-over-IP Tunnel.
is the same IP address as assigned to HNB-GW to communicate with HNB and must be an IP
address in IPv4 or IPv6 notation.
Important:
This command cannot be entered more than once. Only one RTP IP address can be configured for
one HNB-GW service.
Usage
Use this command to enable the HNB-GW IP address as RTP IP address and send the same to HNB to map
RTP streams while HNB-GW communicates with MSC/VLR through IuCS-over-IP tunnel.
This command is used for RTP stream management on HNB-GW.
RTP streams while HNB-GW communicates with MSC/VLR through IuCS-over-IP tunnel.
This command is used for RTP stream management on HNB-GW.
Example
The following command sets the RTP IP address
The following command sets the RTP IP address
on HNB-GW to communicate with HNB while using IuCS-
over-IP tunnel with CS network: