Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
ASN Paging Controller Configuration Mode Commands
peer-asngw ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
peer-asngw
This command provides the facility to configure the addresses of trusted anchor ASN GW peers that a specific ASN
Paging Controller and Location Registry service will allow R4 control and data path registration with.
Paging Controller and Location Registry service will allow R4 control and data path registration with.
Product
ASN PC-LR
Privilege
Administrator
Syntax
Removes the configured peer anchor ASN GW from a specific ASN PC/LR service‘s trusted peer list.
Specifies the IP address of the anchor ASN GW which is added as a trusted peer with the ASN PC/LR
service.
service.
is the IP address of the anchor ASN GW peers expressed in IPv4 dotted decimal or IPv6 colon
separated notation.
Usage
Use this command to create the trusted peer anchor ASN GWs with a specific ASN PC/LR service to
establish R4 control and data path registration.
On receipt of idle mode entry request message the ASN PC/LR service checks whether the Anchor
DPF/Authenticator ASN GW address received in idle mode entry request message is in trusted peer ASN GW
list configured with this command. If the Anchor DPF/Authenticator ASN GW address received in idle mode
entry request message is not there (or not configured) in peer list the ASN PC/LR service sends idle mode
entry response message with Failure Indication TLV with unspecified error code.
A maximum of 32 ASN GWs can be configured with this command.
establish R4 control and data path registration.
On receipt of idle mode entry request message the ASN PC/LR service checks whether the Anchor
DPF/Authenticator ASN GW address received in idle mode entry request message is in trusted peer ASN GW
list configured with this command. If the Anchor DPF/Authenticator ASN GW address received in idle mode
entry request message is not there (or not configured) in peer list the ASN PC/LR service sends idle mode
entry response message with Failure Indication TLV with unspecified error code.
A maximum of 32 ASN GWs can be configured with this command.
Example
The following command adds the anchor ASN GW with an IP address of
The following command adds the anchor ASN GW with an IP address of
as a trusted peer within an ASN PC
service.