Cisco Cisco Packet Data Gateway (PDG) Guía Para Resolver Problemas
CSCF Service Configuration Mode Commands
▀ timeout
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
timeout
Sets timeout values for CSCF and SIP transactions.
Product
SCM
Privilege
Administrator
Syntax
Default: 5
This timer is used by S-CSCF with HSS interface for timeout.
This timer is used by S-CSCF with HSS interface for timeout.
must be an integer from 0 to 2147483646.
Default: 100
This timer is specially used for No-Answer Call Feature executed by S-CSCF. The timer will be started as
soon as 180 Ringing response is received and No-Answer call feature is enabled. The value of this timer
should be always less than INVITE Timeout used by DC-SIP.
This timer is specially used for No-Answer Call Feature executed by S-CSCF. The timer will be started as
soon as 180 Ringing response is received and No-Answer call feature is enabled. The value of this timer
should be always less than INVITE Timeout used by DC-SIP.
must be an integer from 0 to 2147483646.
Default: 5
This timer is used by the P-CSCF/A-BG with Policy interface for timeout.
This timer is used by the P-CSCF/A-BG with Policy interface for timeout.
must be an integer from 0 to 2147483646.
Sets transaction and expiry timers for SIP.
: This timer is used to control the retransmission of 200OK messages to INVITEs after an
ACK is sent. The ACK transaction is cleared after this period. This timer is applicable only for
unreliable transport.
unreliable transport.
must be an integer from 0 to 2147483646. Default: 64*T1 (128 seconds,
recommended minimum)
: This timer is used to control the time interval between each retransmission. The
interval doubles after each retransmission. This is used by P-CSCF/A-BG only when it sending
message toward the UE. Example: T1, 2T1, 4T2, etc. This timer is applicable only for unreliable
message toward the UE. Example: T1, 2T1, 4T2, etc. This timer is applicable only for unreliable