Cisco Cisco Packet Data Gateway (PDG) Guía Para Resolver Problemas
Global Configuration Mode Commands
threshold asngw-session-setup-timeout ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold asngw-session-setup-timeout
Configures thresholds to generate alert/alarm for session setup timeouts in an ASN-GW service.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Syntax
Default: 0
The high threshold number of timeouts during session setup that must be met or exceeded within the polling
interval to generate an alert or alarm.
The high threshold number of timeouts during session setup that must be met or exceeded within the polling
interval to generate an alert or alarm.
can be configured to any integer value between 0 and 10000000. A value of 0 disables the
threshold.
Default: 0
The low threshold number of timeouts during session setup that maintains a previously generated alarm
condition. If the number of denials falls beneath the low threshold within the polling interval, a clear alarm
will be generated.
The low threshold number of timeouts during session setup that maintains a previously generated alarm
condition. If the number of denials falls beneath the low threshold within the polling interval, a clear alarm
will be generated.
can be configured to any integer value between 0 and 10000000. A value of 0 disables the
threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set threshold limits to generate alerts or alarms based on the number of timeouts during
session setup that occurred during the specified polling interval.
Alerts or alarms are triggered for session setup timeouts based on the following rules:
session setup that occurred during the specified polling interval.
Alerts or alarms are triggered for session setup timeouts based on the following rules:
Enter condition: Actual number of failures ³ High Threshold
Clear condition: Actual number of failures < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.
Example