Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
ASN Gateway Service Configuration Mode Commands
peer-asngw ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
peer-asngw
Use this command to configure the addresses of trusted non-anchor ASN GWs or ASN PC/LR peers for which a
specific ASN GW service can allow R4 control and data path registration.
specific ASN GW service can allow R4 control and data path registration.
Product
ASN GW
Privilege
Administrator
Syntax
Removes the configured non-anchor ASN GW or non-anchor ASN PC/LR peers from a specific ASN GW
service‘s trusted peer list.
service‘s trusted peer list.
Specifies the IP address of the non-anchor ASN GW or non-anchor ASN PC/LR peers. The IP address is
added as a trusted peer with the ASN GW service.
added as a trusted peer with the ASN GW service.
is the IP address of the non-anchor ASN GW or non-anchor ASN PC/LR peers expressed in
IPv4 dotted decimal or IPv6 colon separated notation.
Usage
Use this command to create trusted non-anchor ASN GW or non-anchor ASN PC/LR peers with a specific
ASN GW service to establish R4 control and data path registration. The ASN GW supports the 6-byte
ASNGW ID in the souce ID TLV and destination ID TLV of all the messages. The 6-byte anchor gateway ID
and authenticator ID are also supported.
On receipt of an R4 control or data path registration request message, the ASN GW service checks whether a
non-anchor DPF/Authenticator ASN GW/ASN PC-LR address received in a request message, is in the trusted
peer list configured with this command. If the Anchor DPF/Authenticator ASN GW/ASN PC-LR address is
not configured in the non-anchor ASN GW or non-anchor ASN PC/LR peers‘ list, the ASN GW service
sends a response for a request message with Failure Indication TLV and unspecified error code.
You can configure a maximum of 32 ASN GWs or ASN PC/LRs with this command.
ASN GW service to establish R4 control and data path registration. The ASN GW supports the 6-byte
ASNGW ID in the souce ID TLV and destination ID TLV of all the messages. The 6-byte anchor gateway ID
and authenticator ID are also supported.
On receipt of an R4 control or data path registration request message, the ASN GW service checks whether a
non-anchor DPF/Authenticator ASN GW/ASN PC-LR address received in a request message, is in the trusted
peer list configured with this command. If the Anchor DPF/Authenticator ASN GW/ASN PC-LR address is
not configured in the non-anchor ASN GW or non-anchor ASN PC/LR peers‘ list, the ASN GW service
sends a response for a request message with Failure Indication TLV and unspecified error code.
You can configure a maximum of 32 ASN GWs or ASN PC/LRs with this command.
Example
The following command adds the ASN GW with an IP address as a trusted peer within an ASN GW service, and a 6-
byte ID for the peer ASN GW.
The following command adds the ASN GW with an IP address as a trusted peer within an ASN GW service, and a 6-
byte ID for the peer ASN GW.