Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Context Configuration Mode Commands
pgw-service ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
pgw-service
Creates an P-GW service or specifies an existing P-GW service and enters the P-GW Service Configuration Mode for
the current context.
the current context.
Product
P-GW
Privilege
Administrator
Syntax
Specifies the name of the P-GW service. If
does not refer to an existing service, the new
service is created if resources allow.
must be from 1 to 63 alpha and/or numeric characters.
Indicates that the command is to execute without any additional prompt and confirmation from the user.
Removes the specified P-GW service from the context.
Usage
Enter the P-GW Service Configuration Mode for an existing service or for a newly defined service. This
command is also used to remove an existing service.
A maximum of 256 services (regardless of type) can be configured per system.
command is also used to remove an existing service.
A maximum of 256 services (regardless of type) can be configured per system.
Caution:
Large numbers of services greatly increase the complexity of management and may impact overall
system performance (for example, resulting from such things as system handoffs). Therefore, it is recommended that a
large number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.
large number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.
Entering this command results in the following prompt:
P-GW Service Configuration Mode commands are defined in the P-GW Service Configuration Mode
Commands chapter.
Use this command when configuring the following eHRPD and SAE components: P-GW.
Commands chapter.
Use this command when configuring the following eHRPD and SAE components: P-GW.
Example