Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
HA Service Configuration Mode Commands
bind ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
bind
Binds the HA service to a logical IP interface serving as the Pi interface and specifies the maximum number of
subscribers that can access this service over the interface.
subscribers that can access this service over the interface.
Product
HA
Privilege
Security Administrator, Administrator
Syntax
[
]
Specifies the IP address (address) of the interface configured as the Pi interface. address is specified in dotted
decimal notation.
decimal notation.
Default: 500000
Specifies the maximum number of subscribers that can access this service on this interface.
Specifies the maximum number of subscribers that can access this service on this interface.
can be configured to any integer value between 0 and 4,000,000.
Important:
The maximum number of subscribers supported is dependant on the license key installed and the
number of active PACs/PSCs installed in the system. A fully loaded system with 13 active PACs/PSCs can support
1,000,000 total subscribers. Refer to the license key command for additional information.
1,000,000 total subscribers. Refer to the license key command for additional information.
Usage
Associate the HA service to a specific logical IP address. The logical IP address or interface takes on the
characteristics of an Pi interface. Only one interface can be bound to a service. The interface should be
configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
characteristics of an Pi interface. Only one interface can be bound to a service. The interface should be
configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
option, be sure to consider the following:
The total number of interfaces that you will configuring for use as Pi interfaces
The maximum number of subscriber sessions that all of these interfaces may handle during peak busy
hours
The average bandwidth for each of the sessions
The type of physical port (10/100Base-T or 1000Base-Tx) that these interfaces will be bound to
Taking these factors into account and distributing your subscriber session across all available interfaces will
allow you to configure your interfaces to optimally handle sessions without degraded performance.
Use the
allow you to configure your interfaces to optimally handle sessions without degraded performance.
Use the
command to delete a previously configured binding.