Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
HA Service Configuration Mode Commands
▀ optimize tunnel-reassembly
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
optimize tunnel-reassembly
Configures HA to FA optimization for tunnel reassembly.
Product
HA
Privilege
Security Administrator, Administrator
Syntax
Usage
Enabling this functionality fragments large packets prior to encapsulation for easier processing.
Tunnel reassembly optimization is disabled by default.
Tunnel reassembly optimization is disabled by default.
Important:
Cisco Systems strongly recommends that you do not use this command without first consulting Cisco
Systems Technical Support. This command applies to very specific scenarios where packet reassembly is not supported
at the far end of the tunnel. There are cases where the destination network may either discard the data, or be unable to
reassemble the packets.
at the far end of the tunnel. There are cases where the destination network may either discard the data, or be unable to
reassemble the packets.
Important:
This functionality works best when the HA service is communicating with an FA service running in
a system. However, an HA service running in the system communicating with an FA from a different manufacturer will
operate correctly even if this parameter is enabled.
operate correctly even if this parameter is enabled.
Use the
version of this command to disable tunnel optimization if enabled.
Example
The following command enables tunnel reassembly optimization:
The following command enables tunnel reassembly optimization: