Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
HSGW Service Configuration Mode Commands
bind address ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
bind address
Binds the service to a logical IP interface serving as the A10 interface and specifies the maximum number of subscribers
that can access this service over the configured interface.
that can access this service over the configured interface.
Product
HSGW
Privilege
Administrator
Syntax
Removes the interface binding from this service.
Specifies the IPv4 address of the interface configured as the A10/A11 interface.
is specified in
dotted decimal notation.
Default: 2500000
Specifies the maximum number of subscribers that can access this service on this interface.
Specifies the maximum number of subscribers that can access this service on this interface.
must be
configured to an integer between 0 and 2,500,000.
Important:
The maximum number of subscribers supported is dependant on the license key installed and the
number of active PSCs in the system. A fully loaded system with 13 active PSCs can support 3,000,000 total
subscribers. Refer to the license key command and the Usage section (below) for additional information.
subscribers. Refer to the license key command and the Usage section (below) for additional information.
Usage
Associate the HSGW service to a specific logical IP address. The logical IP address or interface takes on the
characteristics of an A10/A11 interface that provides the session connectivity to/from an eAN/PCF. Only one
interface can be bound to a service. The interface should be configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
characteristics of an A10/A11 interface that provides the session connectivity to/from an eAN/PCF. Only one
interface can be bound to a service. The interface should be configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
option, be sure to consider the following:
The total number of A10/A11 interfaces you will configure
The total number of subscriber sessions that all of the configured interfaces may handle during peak
busy hours
An average bandwidth per session multiplied by the total number of sessions
The type of physical port (10/100Base-T or 1000Base-Tx) that these interfaces will be bound to