Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
MME Service Configuration Mode Commands
▀ pgw-address
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
pgw-address
This command configures the PDN Gateway (P-GW) address to use P-MIP protocol for S5 and S8 interface and other
parameters with MME service. By default S5 and S8 use GTP protocol for this.
parameters with MME service. By default S5 and S8 use GTP protocol for this.
Product
MME
Privilege
Security Administrator, Administrator
Syntax
Removes a previously configured IP address of P-GW along with S5 and S8 interface of P-MIP protocol type
and other parameters from this MME service.
and other parameters from this MME service.
Specifies the IP address of the P-GW.
must be an IP address in IPv4 or IPv6 notation.
Specifies that P-MIP type of protocol to use for S5 and S8 interfaces with P-GW. By default S5 and S8
interface uses GTP protocol.
interface uses GTP protocol.
Sets the protocol to Proxy-MIP for S5 and S8 interface as by default GTP is the applicable protocol.
Assigns the weight to P-GW address to use as a preferred P-GW.
must be an integer from 1 through 100. Lowest value has the least preference.
Usage
Use this command to configure the PDN Gateway (P-GW) addresses to use with MME service. This
command also changes the default protocol or GTP to P-MIP for the S5 and S8 interface and weight to share
the load between associated P-GWs. A maximum of 16 P-GW addresses can be configured with this
command.
This command only changes the use of protocol in S5 and S8 interface. By default P-GW uses GTP protocol
for S5 and S8 interfaces. By this command user can change the protocol to P-MIP for S5 and S8 interface.
When weight is used, the weights of the P-GW(s) (that are operational) are totaled and then weighted round-
robin selection is used to distribute new default bearer context among the P-GW(s) according to their
weights.
command also changes the default protocol or GTP to P-MIP for the S5 and S8 interface and weight to share
the load between associated P-GWs. A maximum of 16 P-GW addresses can be configured with this
command.
This command only changes the use of protocol in S5 and S8 interface. By default P-GW uses GTP protocol
for S5 and S8 interfaces. By this command user can change the protocol to P-MIP for S5 and S8 interface.
When weight is used, the weights of the P-GW(s) (that are operational) are totaled and then weighted round-
robin selection is used to distribute new default bearer context among the P-GW(s) according to their
weights.
Example