Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Policy Control Configuration Mode Commands
diameter host-select reselect ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
diameter host-select reselect
This command controls pacing of the reselection or switching of the PCRF after a change occurs in table configuration
for an IMS Authorization Service.
for an IMS Authorization Service.
Default: Disabled
Product
All
Privilege
Security Administrator, Administrator
Syntax
Applies the default setting for this command.
Sets the PCRF reselection or switching to default state.
Sets the PCRF reselection or switching to default state.
Removes the configured PCRF reselection method and disables the reselection or switching of PCRF.
Specifies the limit of subscribers to switch or reselect the PCRF for subscribers not more than
in time duration of
second(s).
must be an integer from 1 through 10000000.
Specifies the time duration, in seconds, to reselect PCRF for subscribers not more than
in time
duration of
second(s).
must be an integer from 1 through 3600.
Usage
Use this command to specify the pacing of reselection or switching of the PCRF in an IMS authorization
service..
In case IMS authorization session have been opened on certain PCRF on the basis of the current selection
table, and the current active table configuration is changed, the IMSA starts selection procedure for the
PCRF. Existing sessions on current PCRF from earlier table is required to close and reopened on the selected
PCRF from the new table. This reselection periodicity is controlled by this command and it indicates the
number of subscriber sessions
service..
In case IMS authorization session have been opened on certain PCRF on the basis of the current selection
table, and the current active table configuration is changed, the IMSA starts selection procedure for the
PCRF. Existing sessions on current PCRF from earlier table is required to close and reopened on the selected
PCRF from the new table. This reselection periodicity is controlled by this command and it indicates the
number of subscriber sessions
to be reselected or moved in
seconds.
For example, if this command is configured with
subscribers and seconds, then the system reselects
the PCRF for no more than
subscribers per seconds.