Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Subscriber Configuration Mode Commands
▀ qos traffic-police
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
qos traffic-police
Enables and configures traffic policing through the bandwidth limits and action for the subscriber traffic if it
exceeds/violates the peak or committed data rate. Uplink and downlink limits are configured separately.
exceeds/violates the peak or committed data rate. Uplink and downlink limits are configured separately.
Product
PDSN, HA, GGSN, ASN GW
Privilege
Security Administrator, Administrator
Syntax
Apply the specified limits and actions to the downlink (data to the subscriber).
Apply the specified limits and actions to the uplink (data from the subscriber).
Default: 3000
The peak burst size allowed, in bytes.
The peak burst size allowed, in bytes.
must be an integer from 0 through 4294967295.
Important:
It is recommended that this parameter be configured to at least the greater of the following two
values: 1) 3 times greater than packet MTU for the subscriber connection, OR 2) 3 seconds worth of token accumulation
within the ―bucket‖ for the configured peak-data-rate.
within the ―bucket‖ for the configured peak-data-rate.
Default: 144000
The committed data rate (guaranteed-data-rate) in bps (bits per second).
The committed data rate (guaranteed-data-rate) in bps (bits per second).
must be an integer from 0 through 4294967295).
Default: lower-ip-precedence
The action to take on the packets that exceed the committed-data-rate but do not violate the peak-data-rate.
The following actions are supported:
The action to take on the packets that exceed the committed-data-rate but do not violate the peak-data-rate.
The following actions are supported:
: Drop the packet
: Transmit the packet after lowering the ip-precedence
: Transmit the packet