Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
ACS Rulebase Configuration Mode Commands
▀ transport-layer-checksum
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
transport-layer-checksum
This command enables/disables checksum verification for TCP and UDP packets.
Product
ACS
Privilege
Security Administrator, Administrator
Syntax
Disables the checksum calculation for the specified packet type.
Configures the default setting.
Default:
Default:
—to perform the
checksum verification calculation on all TCP and UDP packets.
Specifies that either TCP or UDP packets should be verified or not verified.
If neither of these keywords is specified the command applies to both TCP and UDP packets.
If neither of these keywords is specified the command applies to both TCP and UDP packets.
Usage
Use this command to disable or enable performing checksum verification calculations on TCP or UDP
packets.
If the checksum is not verified, the packets will go through the TCP/UDP analyzers (and deeper analyzers, if
so configured with the
packets.
If the checksum is not verified, the packets will go through the TCP/UDP analyzers (and deeper analyzers, if
so configured with the
CLI command) regardless of the value of the TCP/UDP checksum.
If the checksum is verified, only packets with good checksums will go through the TCP/UDP analyzers (and
deeper analyzers, if so configured).
deeper analyzers, if so configured).
Example
The following command disables checksum verification calculations on all TCP and UDP packets:
The following command disables checksum verification calculations on all TCP and UDP packets: