Cisco Cisco Packet Data Gateway (PDG) Guía Para Resolver Problemas
L2TP Access Concentrator
Configuring LAC Services ▀
Cisco ASR 5000 Series Enhanced Feature Configuration Guide ▄
OL-22982-01
Configuring LAC Services
Important:
Not all commands, keywords and functions may be available. Functionality is dependent on platform
and license(s).
This section provides information and instructions for configuring LAC services on the system allowing it to
communicate with peer LNS nodes.
communicate with peer LNS nodes.
Important:
This section provides the minimum instruction set for configuring LAC service support on the
system. For more information on commands that configure additional parameters and options, refer LAC Service
Configuration Mode Commands chapter in Command Line Interface Reference.
Configuration Mode Commands chapter in Command Line Interface Reference.
To configure the LAC services on system:
Step 1
Configure the LAC service on system and bind it to an IP address by applying the example configuration in the
Configuring LAC Service section.
Configuring LAC Service section.
Step 2
Optional. Configure LNS peer information if the Tunnel-Service-Endpoint attribute is not configured in the subscriber
profile or PDSN compulsory tunneling is supported by applying the example configuration in the Configuring LNS Peer
section.
profile or PDSN compulsory tunneling is supported by applying the example configuration in the Configuring LNS Peer
section.
Step 3
Verify your LAC configuration by following the steps in the Verifying the LAC Service Configuration section.
Step 4
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Configuring LAC Service
Use the following example to create the LAC service and bind the service to an IP address:
Notes:
<
> is the destination context where you want to configure the LAC service.