Cisco Cisco Packet Data Gateway (PDG) Guía Para Resolver Problemas
PDG/TTG Configuration
Configuring the System to Perform as a TTG ▀
Cisco ASR 5000 Series Packet Data Gateway/Tunnel Termination Gateway Administration Guide ▄
OL-22999-01
Required
Information
Information
Description
Security
administrator
password
administrator
password
Open or encrypted passwords can be used.
Remote access
type(s)
type(s)
The type of remote access that will be used to access the system such as ftpd and/or telnetd.
Required PDG Context Configuration Information
The following table lists the information that is required to configure the PDG context.
Table 5. Required Information for PDG Context Configuration
Required Information
Description
PDG context name
An identification string from 1 to 79 characters (alpha and/or numeric) by which the PDG context
is recognized by the system.
is recognized by the system.
Configuration for the Secure Interface to the UEs in the WLAN
WLAN interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the
interface is recognized by the system.
This is the Wu interface that carries IPSec tunnels between the UEs in the WLAN and the
PDG/TTG.
interface is recognized by the system.
This is the Wu interface that carries IPSec tunnels between the UEs in the WLAN and the
PDG/TTG.
AAA interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the
interface is recognized by the system.
This is the Wm interface between the AAA server and the PDG/TTG.
interface is recognized by the system.
This is the Wm interface between the AAA server and the PDG/TTG.
Loopback interface
An identification string between 1 and 79 characters (alpha and/or numeric) by which the
interface is recognized by the system.
This is the PDG/TTG loopback interface.
interface is recognized by the system.
This is the PDG/TTG loopback interface.
IP addresses and subnet
masks
masks
IPv4 addresses and subnet masks assigned to the WLAN, AAA, and loopback interfaces above.
Physical Ethernet port
numbers
numbers
The physical Ethernet port to which the PDG interface will be bound. Ports are identified by the
chassis slot number where the line card resides followed by the number of the physical connector
on the card. For example, port 17/1 identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
chassis slot number where the line card resides followed by the number of the physical connector
on the card. For example, port 17/1 identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP address
The gateway IP address for configuring the IP route from the PDG interface to the WLAN.
AAA configuration
information
information
Identify the IP addresses of the RADIUS/Diameter server.
EAP profile name(s)
(required for the EAP
authentication method)
(required for the EAP
authentication method)
The name(s) of the EAP profile(s) to be used for UE authentication.
IKEv2 transform set name(s)
The name(s) of the IKEv2 transform set(s) to be used.