Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Troubleshooting the System
Detecting Faulty Hardware Using Component LEDs ▀
Cisco ASR 5000 Series System Administration Guide ▄
OL-22969-02
SPIO Standby LED States
The Standby LED on the SPIO indicates that software is loaded on the card, but it is serving as a redundant component.
For the SPIO installed in slot 25, this LED should be green for normal operation. For the SPIO installed in slot 24, this
LED should be off for normal operation.
For the SPIO installed in slot 25, this LED should be green for normal operation. For the SPIO installed in slot 24, this
LED should be off for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 38.
SPIO Standby LED States
Color
Description
Troubleshooting
Green
Card is in redundant
mode
mode
None needed for SPIO in slot 25. If green for SPIO in slot 24, check the status of the
SPC/SMC installed in slot 8.
If the SPC/SMC in slot 8 is in standby mode, it is possible that there is a problem. Refer to
one or more of the following to help analyze this problem:
SPC/SMC installed in slot 8.
If the SPC/SMC in slot 8 is in standby mode, it is possible that there is a problem. Refer to
one or more of the following to help analyze this problem:
The Monitoring Hardware Status chapter in this reference for show commands; the
outputs of which will assist in further determining the problem.
outputs of which will assist in further determining the problem.
The Configuring and Viewing System Logs chapter in this reference for information
on configuring specific types of logging information and how to view logs.
on configuring specific types of logging information and how to view logs.
SNMP MIB Reference for information on associated status and alarm conditions.
None
Card is not receiving
power OR Card in Active
Mode
power OR Card in Active
Mode
Verify that the RUN/FAIL LED is green. If so, the card is receiving power and
POST test results are positive. If it is off, refer to the SPIO RUN/FAIL LED States
section of this chapter for information on troubleshooting.
POST test results are positive. If it is off, refer to the SPIO RUN/FAIL LED States
section of this chapter for information on troubleshooting.
Check the state of the Active LED. If it is green, the card is in active mode. This is
normal for the SPIO in slot 24 since the chassis automatically make the card active
at boot up.
normal for the SPIO in slot 24 since the chassis automatically make the card active
at boot up.
SPIO Interface Link LED States
The Link LED, associated with a particular SPIO interface indicates the status of the network link. This LED should be
green for normal operation.
green for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 39.
SPIO Interface Link LED States
Color
Description
Troubleshooting