Cisco Cisco Aironet 1400 Wireless Bridge Guía De Instalación
26
If you are at the root bridge site make configuration changes in the non-root
bridge first, then the root bridge. This sequence is required because the link
is lost when the non-root parameters take effect, but it reassociates after the
root bridge’s parameters take effect.
bridge first, then the root bridge. This sequence is required because the link
is lost when the non-root parameters take effect, but it reassociates after the
root bridge’s parameters take effect.
If you are at the non-root bridge site, make configuration changes to the root
bridge first, then the non-root bridge.
bridge first, then the non-root bridge.
Accessing the Setup Pages
Before accessing the bridge’s setup pages, obtain the necessary configuration
information from your network administrator. Then follow these steps to
browse to the bridge’s Express Setup page.
information from your network administrator. Then follow these steps to
browse to the bridge’s Express Setup page.
1.
Open your Internet browser. You must use Microsoft Internet Explorer
(version 5.x or later) or Netscape Navigator (version 4.x or later).
(version 5.x or later) or Netscape Navigator (version 4.x or later).
2.
Enter the bridge’s IP address in the browser address line and press Enter.
An Enter Network Password window appears.
An Enter Network Password window appears.
The default IP address for the root bridge is 10.0.0.1. The IP address for
the non-root bridge can be found by going into the root bridge’s
Associations page and clicking on the MAC address of the non-root
bridge.
the non-root bridge can be found by going into the root bridge’s
Associations page and clicking on the MAC address of the non-root
bridge.
3.
Enter the case-sensitive username Cisco and press the Tab key to
advance to the Password field.
advance to the Password field.