Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación
4
Release Notes for Cisco Aironet 1300 Series Outdoor Access Point/Bridge for Cisco IOS Release 12.3(7)JA2
OL-8818-01
Installation Notes
If the access point/bridge is configured to support EAP authentication of clients and VLAN override is
enabled as part of NAC on the RADIUS server, no additional configuration of the access point/bridge is
required to support NAC.
enabled as part of NAC on the RADIUS server, no additional configuration of the access point/bridge is
required to support NAC.
Procedures for configuring the access point/bridge to support EAP authentication of clients is on
Cisco.com at the following URL:
Cisco.com at the following URL:
Installation Notes
This section contains important information to keep in mind when installing your access point/bridge.
Warnings
Warning
This warning means danger. You are in a situation that could cause bodily injury. Before you work on
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come in contact with such circuits, as they may cause serious injury or death. for proper
installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come in contact with such circuits, as they may cause serious injury or death. for proper
installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than:
120 VAC, 15A U.S. (240vac, 10A International)
the protective device is rated not greater than:
120 VAC, 15A U.S. (240vac, 10A International)
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground connector. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
absence of a suitably installed ground connector. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Warning
Read the installation instructions before you connect the system to its power source.
Warning
Do not work on the system or disconnect cables during periods of lightning activity.