Cisco Cisco Aironet 340 Access Point-RP-TNC Guía De Información
Products & Services
Cisco Aironet Base Station FAQ
Document ID: 8116
Introduction
This document provides information on commonly asked questions about Cisco
Aironet Base Stations.
Aironet Base Stations.
Note: This product has reached the end of its life cycle. Cisco no longer supports
this product after September 3, 2006.
this product after September 3, 2006.
Basics
Q. Where can I download the latest software?
A. Cisco Aironet equipment operates best when you load all
components with current versions of software. You can download the
latest software and drivers at the
components with current versions of software. You can download the
latest software and drivers at the
Cisco Software Center
.
Q. How can I recover forgotten passwords or recall the factory defaults on
the base station?
the base station?
A. Because there is no password setup on the base station, you must
reset the base station to the factory defaults by pressing the Reset
pinhole button for two seconds. When you press this reset, you reset
the unit to its default, out-of-the-box state.
reset the base station to the factory defaults by pressing the Reset
pinhole button for two seconds. When you press this reset, you reset
the unit to its default, out-of-the-box state.
Q. Why does the middle Status LED always blink yellow or amber?
A. The base station starts with default Service Set Identifier (SSID)
and Encryption settings. When a yellow or amber light blinks it is a
visual alert that you have not personalized your installation or changed
the factory default settings. When you change the SSID or Encryption
settings, you change the Status LED to blink or solid green.
and Encryption settings. When a yellow or amber light blinks it is a
visual alert that you have not personalized your installation or changed
the factory default settings. When you change the SSID or Encryption
settings, you change the Status LED to blink or solid green.
Capabilities
Q. What speed is the Ethernet port of the base station?
A. The Ethernet port of the base station supports 10 Mbps in half-
duplex mode over a 10BaseT RJ-45 connector. There is no option to
change the speed and duplex settings on the LAN port.
duplex mode over a 10BaseT RJ-45 connector. There is no option to
change the speed and duplex settings on the LAN port.
Questions
Introduction
Basics
Capabilities
Association
Configuration
IP Addressing
Security
Dialup
Base Station Product Numbers
Related Information