Cisco Cisco Aironet 340 Access Point-RP-TNC Manual Técnica
Upgrading the 340 Aironet Bridge Using FTP
Document ID: 21436
In order to receive Cisco Aironet drivers, firmware and utility software,
follow this link to the Cisco Wireless Downloads (registered customers
only) .
follow this link to the Cisco Wireless Downloads (registered customers
only) .
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Upgrade Procedures
Step−by−Step Instructions
Alternate Upgrade Method
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Upgrade Procedures
Step−by−Step Instructions
Alternate Upgrade Method
Verify
Troubleshoot
Related Information
Introduction
This document describes how to use FTP to upgrade firmware that runs on the Cisco 340 Series Ethernet
Bridge and 340 Series Workgroup Bridge.
Bridge and 340 Series Workgroup Bridge.
Prerequisites
Requirements
In order to perform the upgrade, you need an FTP server on which to place the image that you load.
Components Used
The information in this document is based on the Cisco 340 Series Ethernet Bridge and 340 Series Workgroup
Bridge.
Bridge.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Upgrade Procedures
There are three methods used to upgrade the Cisco 340 Bridge and 340 Workgroup Bridge firmware. These
methods are:
methods are: