Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación
5
Release Notes for Cisco Aironet 1310 Outdoor Access Point/Bridge for Cisco IOS Release 12.3(2)JA6
OL-10200-01
Installation Notes
IP-Redirect
This features provides the capability to redirect traffic intended for a particular destination to another IP
address specified by the administrator.
address specified by the administrator.
Features Not Supported
The following features that were introduced in Cisco IOS Release 12.2(13)JA or earlier that are not
supported by the access point/bridge:
supported by the access point/bridge:
•
Radio management
•
Radio management aggregation
•
Layer 3 Mobility Service via fast secure roaming tunnels
•
Wireless Domain Services (WDS)
•
IEEE 802.11a support
Installation Notes
This section contains important information to keep in mind when installing your access point/bridge.
Warnings
Warning
This warning means danger. You are in a situation that could cause bodily injury. Before you work on
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come in contact with such circuits, as they may cause serious injury or death. for proper
installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come in contact with such circuits, as they may cause serious injury or death. for proper
installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than:
120 VAC, 15A U.S. (240vac, 10A International)
the protective device is rated not greater than:
120 VAC, 15A U.S. (240vac, 10A International)