Cisco Cisco Aironet 1400 Wireless Bridge Guía De Instalación

Make sure the following physical site issues are resolved before beginning the installation:

Identify the roof area, wall, or tower for mounting the bridge. You must choose a site with a clear 
radio path to the remote bridge.

Determine the roof access point, such as stairway or ladder.

Identify existing equipment installations and assess the condition of proposed towers or mounting 
structures. 

Assess environmental conditions, such as temperature, ventilation, and humidity.

Make sure the following cable route issues are resolved before beginning the installation:

Determine cable routes, building entry points, and any special routing or support requirements 
(conduits, bracing, cable trays, safety structures, and so on). Make sure the total cable length 
between bridge and the Power Injector LR is no greater than 100 meters.

Identify necessary floor, roof, or wall penetrations and specify the locations.

Install a new grounding system or ensure the existing grounding system complies with the National 
Electrical Code.

This section describes the required tools, cables, and fasteners.

Mounting the bridge requires the following tools:

13 mm wrench or socket

#2 Phillips screwdriver

Crimping tool for F-connectors that accommodates RG6/U cable (http://www.tessco.com)

Crimping tool for ground lug, Panduit CT-1004 or equivalent (http://onlinecatalog.panduit.com)

Voltmeter and BNC-terminated probe (RSSI voltage alignment only)

You may also require tools for user-supplied hardware or fasteners.

Cisco recommends using RG6 coaxial cable. 

 and 

 lists possible coaxial cables for the 

bridge to power injector connections: