Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación
2
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.4(3g)JA
OL-11736-01
System Requirements
You can configure and monitor 1130 and 1240 series access points, 1300 series outdoor access
point/bridges, and 1400 series bridges using the command-line interface (CLI), the web-browser
interface, or Simple Network Management Protocol (SNMP).
point/bridges, and 1400 series bridges using the command-line interface (CLI), the web-browser
interface, or Simple Network Management Protocol (SNMP).
System Requirements
You can install Cisco IOS Release 12.4(3g)JA on all 1130, 1240 series access points, 1300 series outdoor
access point/bridges, and 1400 series bridges.
access point/bridges, and 1400 series bridges.
Finding the IOS Software Version
To find the version of IOS software running on your access point, use a Telnet session to log into the
access point and enter the show version EXEC command. This example shows command output from
an access point running Cisco IOS Release 12.4(3g)JA:
access point and enter the show version EXEC command. This example shows command output from
an access point running Cisco IOS Release 12.4(3g)JA:
ap1240AG>show version
Cisco Internetwork Operating System Software
IOS (tm) C1240 Software (C1240-K9W7-M), Version 12.4(3g)JA
Copyright (c) 1986-2007 by Cisco Systems, Inc.
On access points running IOS software, you can also find the software version on the System Software
Version page in the access point’s web-browser interface. If your access point does not run IOS software,
the software version appears at the top left of most pages in the web-browser interface.
Version page in the access point’s web-browser interface. If your access point does not run IOS software,
the software version appears at the top left of most pages in the web-browser interface.
Upgrading to a New Software Release
For instructions on installing access point software for your access point:
Step 1
Follow this link to the Cisco home page:
Step 2
Click Support. The Support page appears.
Step 3
Click See Documentation. The Documentation page appears.
Step 4
Click Wireless. The Wireless Support Resources page appears.
Step 5
Scroll down to the Access Points section.
Step 6
Select the access point model for which you need the information. The Introduction page for the model
you selected appears.
you selected appears.
Step 7
Under the Configure section, click Configuration Guides. A list of configuration documents appears.
Step 8
Click Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 12.4(3g)JA.
Step 9
Navigate to the Managing Firmware and Software chapter.
For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on
Cisco.com:
Cisco.com: