Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación

Descargar
Página de 17
 
3
Release Notes for Cisco Aironet 1300 Series Outdoor Access Point/Bridge for Cisco IOS Release 12.3(4)JA2
OL-8216-01
  Updates to Existing Features
Step 8
Click Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 12.3(2)JA.
Step 9
Navigate to the Managing Firmware and Software chapter.
For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on 
Cisco.com: 
Updates to Existing Features
These existing features are now supported on access points/bridges running Cisco IOS Release 
12.3(4)JA:
IP-Based Wireless Domain Services (WDS)
Layer 3 Mobility Service via Fast Secure Roaming Tunnels
Access point/bridge as a repeater access point
Access point/bridge as non root bridge with clients
New Features
This release does not contain new features. It supports the features introduced in Cisco IOS Release 
12.3(4)JA. This section lists new features in Cisco IOS Release 12.3(4)JA for the access point/bridge.
The following new features are supported by the access point/bridge:
Support for multiple basic SSIDs (mBSSID)
Support Wi-Fi 802.11h and Dynamic Frequency Selection (DFS)
Wireless IDS - Excess Management Frame Detection
Wireless IDS - Authentication Attack Detection 
Wireless IDS - Active termination for managed clients
Frame Monitor Mode
Location Based Services
SNMPv3
Support for Multiple Basic SSIDs
This feature permits a single access point to appear to the WLAN as multiple virtual access points.  It 
does this by assigning an access point with multiple Basic Service Set IDs (MBSSIDs) or MAC 
addresses.