Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación
16
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(8)JEA1
OL-12427-01
Caveats
Pings and Link Tests Sometimes Fail to Clients with Both Wired and Wireless
Network Connections
Network Connections
When you ping or run a link test from an access point to a client device installed in a PC running
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Layer 3 Mobility Not Supported on Repeaters and Workgroup Bridges
Repeater access points and workgroup bridges cannot associate to an SSID configured for Layer 3
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.
WLSM Required for Layer 3 Mobility
You must use a Wireless LAN Services Module (WLSM) as your WDS device in order to properly
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not
support Layer 3 mobility, client devices cannot associate using that SSID.
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not
support Layer 3 mobility, client devices cannot associate using that SSID.
Caveats
This section lists open and resolved caveats for .
Open Caveats
These caveats are open in Cisco IOS Release 12.3(8)JEA1:
•
CSCsc94510—GUI can set illegal combination of Low Latency Rates
The GUI can set an illegal combination of low latency rates on the access point. Rates of 48 and
54Mbps set as both nominal and non-nominal can occur. Once the rates are set, you can not disable
them and they stay set as non-nominal.
54Mbps set as both nominal and non-nominal can occur. Once the rates are set, you can not disable
them and they stay set as non-nominal.
•
CSCsc83206—A nested repeater access point fails to notify radar detection
If radar is detected on a nested repeater in a nested repeater chain, no action is being taken by either
the repeater or root/parent to notify the detection.
the repeater or root/parent to notify the detection.
•
CSCse34644—Shared authentication with a non-native vlan does not operate properly
•
CSCsd69733—Hot standby access point cannot associate
The hot standby access point almost always fails to authenticate with the error cannot associate: Not
standby parent (from incorrect mac address. The incorrect mac address is the mac address of another
access point on the same network but not its parent device's mac address. In other words, the hot
standby unit attempts to authenticate with an access point that is not it's parent and fails.
standby parent (from incorrect mac address. The incorrect mac address is the mac address of another
access point on the same network but not its parent device's mac address. In other words, the hot
standby unit attempts to authenticate with an access point that is not it's parent and fails.