Cisco Cisco Aironet 1310 Access Point Bridge Guía De Instalación

The optional roof mount kit contains these items:

One roof-wall mount

Two dual-coax cables [20 ft (6.1 m) and 50 ft (15.2 m)]

Multi-function mount (consisting of a bridge bracket and a mast bracket) 

Two tower clamps (U-bolts) with four nuts and washers

Four bolts and washers for securing the bridge bracket to the mast bracket

Four bolts for securing the bridge bracket to the unit

Grounding block and mounting screws

Ground lug for the bridge, two hex nuts, and two washers

Weatherproofing kit (consisting of Coax Seal and electrical joint compound)

The optional wall mount kit (for indoor use) contains these items:

Wall mount bracket with 4 mounting bolts and washers

Two sub-mini RG-59 coax cables (12 in. or 30.5 cm)

Translated versions of the following safety warnings are provided in the Appendix A, “Translated Safety 
Warnings” section of the Cisco Aironet 1300 Series Wireless Bridge Hardware Installation Guide.

This warning symbol means danger. You are in a situation that could cause bodily injury. Before 
you work on any equipment, be aware of the hazards involved with electrical circuitry and be 
familiar with standard practices for preventing accidents. (To see translations of the warnings 
that appear in this publication, refer to the appendix “Translated Safety Warnings.”) Statement 84

Do not operate your wireless network device near unshielded blasting caps or in an explosive 
environment unless the device has been modified to be especially qualified for such use. 
Statement 245B

In order to comply with international radio frequency (RF) exposure limits, dish antennas should be 
placed at a minimum of 8.7 inches (22 cm) from the bodies of all persons. Other antennas should be 
placed a minimum of 7.9 inches (20 cm) from the bodies of all persons. Statement 246

Do not work on the system or connect or disconnect cables during periods of lightning activity. 
Statement 1001