Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación

You can install Cisco IOS Release 12.4(3g)JA1 on all 1130, 1240 series access points, 1300 series 
outdoor access point/bridges, and 1400 series bridges.

To find the version of Cisco IOS software running on your access point, use a Telnet session to log into 
the access point, and enter the show version EXEC command. This example shows command output 
from an access point running Cisco IOS Release 12.4(3g)JA:

ap1240AG> show version

Cisco Internetwork Operating System Software

IOS (tm) C1240 Software (C1240-K9W7-M), Version 12.4(3g)JA

Copyright (c) 1986-2007 by Cisco Systems, Inc.

On access points running Cisco IOS software, you can also find the software version on the System 
Software Version page in the access point’s web-browser interface. If your access point does not run 
Cisco IOS software, the software version appears at the top left of most pages in the web-browser 
interface. 

Follow these steps for instructions on upgrading your access point or bridge software:

Follow this link to the Cisco home page:

Click Support. The Support page appears.

Click See Documentation. The Documentation page appears.

Click Wireless. The Wireless Support Resources page appears.

Scroll down to the Access Points section.

Select the access point model for which you need the information. The Introduction page for the model 
that you selected appears.

Under the Configure section, click Configuration Guides. A list of configuration documents appears.

Click Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 12.4(3g)JA. 

Navigate to the Managing Firmware and Software chapter.

For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on 
Cisco.com: