Cisco Cisco Aironet 350 Workgroup Bridges Notas de publicación
4
Release Notes for Cisco Aironet Workgroup Bridges Running Firmware Release 8.84
OL-4149-01
Installation Notes
Installation Notes
Verify Mounting Hole Measurement
If you make a photocopy of the mounting template (included in Mounting Instructions for the Cisco
Aironet Access Points, Base Stations, and Workgroup Bridges with Plastic Cases), make sure that the
distance between the holes is 4 3/4 in. (12.06 cm) before you drill the holes. Some photocopy machines
do not make exact duplicates of the original.
Aironet Access Points, Base Stations, and Workgroup Bridges with Plastic Cases), make sure that the
distance between the holes is 4 3/4 in. (12.06 cm) before you drill the holes. Some photocopy machines
do not make exact duplicates of the original.
Important Notes
Cisco Aironet Software Requires Completion of Encryption Authorization Form
In order to access Cisco Aironet software from the Software Center on Cisco.com, you must now fill out
a form to receive authorization to download encrypted software. Registered Cisco.com users are required
to fill out the form only once, while public users must do so once each session, each time software is
downloaded. A form is automatically created for public users. The form for registered Cisco.com users
is located at the following URL:
a form to receive authorization to download encrypted software. Registered Cisco.com users are required
to fill out the form only once, while public users must do so once each session, each time software is
downloaded. A form is automatically created for public users. The form for registered Cisco.com users
is located at the following URL:
Bridge Loop May Occur with Incorrect Network Topology
If the workgroup bridge is connected to the wired LAN and is communicating with an access point on
the same LAN, a network problem known as a bridge loop can occur. Avoid a bridge loop by
disconnecting the workgroup bridge from the wired LAN immediately after you configure it. Figure 1
shows the network configuration in which the loop occurs.
the same LAN, a network problem known as a bridge loop can occur. Avoid a bridge loop by
disconnecting the workgroup bridge from the wired LAN immediately after you configure it. Figure 1
shows the network configuration in which the loop occurs.
Figure 1
Bridge Loop Caused by a Workgroup Bridge Connected to the Wired LAN
ETHERNET
SPEED
1
5
2
6
3
7
4
8
LED
100BaseT
X SOLID
10BaseT
BLINK
1X
2X
3X
4X
5X
6X
7X
MDI
MDI-X
8X
Wired LAN
Access point
Workgroup bridge
Hub
44712