Cisco Cisco Aironet 350 Access Points Notas de publicación
8
Release Notes for Cisco Aironet 350, 1100, and 1200 Series Access Points for Cisco IOS Release 12.2(15)JA
OL-5263-01
Important Notes
Unpowered 1100 Series Access Points Cause Loopback When Connected to Switches Without
Loopback Detection
Loopback Detection
When you connect an unpowered 1100 series access point to a switch without loopback detection, the
access point causes a loopback. To avoid this problem, make sure loopback detection is enabled on the
switch to which the access point is connected. If your switch does not have loopback detection,
disconnect the access point from the switch when the access point power is off.
access point causes a loopback. To avoid this problem, make sure loopback detection is enabled on the
switch to which the access point is connected. If your switch does not have loopback detection,
disconnect the access point from the switch when the access point power is off.
Antenna Installation
For instructions on the proper installation and grounding of external antennas for 1200 series access
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
Warning
Do not install the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Important Notes
This section describes important information about the access point.
TFTP Required to Upgrade 1200 Series Access Points to this Release
Software upgrades fail when you use the web-browser interface to install Cisco IOS Release 12.2(15)JA
on 1200 series access points. The image size exceeds the access point’s 4-MB restriction for software
upgrades. Use TFTP to upgrade your 1200 series access point to this release. For complete instructions
on using TFTP to upgrade access point software, see the Cisco IOS Software Configuration Guide for
Cisco Aironet Access Points on Cisco.com:
on 1200 series access points. The image size exceeds the access point’s 4-MB restriction for software
upgrades. Use TFTP to upgrade your 1200 series access point to this release. For complete instructions
on using TFTP to upgrade access point software, see the Cisco IOS Software Configuration Guide for
Cisco Aironet Access Points on Cisco.com:
Default Username and Password Are Cisco
When you open the access point interface, you must enter a username and password. The default
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
New Express Security Page Simplifies Security Setup
The new Express Security page in the access point web-browser interface makes it easier to create SSIDs
and assign security settings to them.
and assign security settings to them.
shows the Express Security page.
Limitations of the Express Security page include:
•
You cannot edit SSIDs. However, you can delete SSIDs and re-create them.
•
You cannot assign SSIDs to specific radio interfaces. The SSIDs that you create are enabled on all
radio interfaces. To assign SSIDs to specific radio interfaces, use the Security SSID Manager page.
radio interfaces. To assign SSIDs to specific radio interfaces, use the Security SSID Manager page.